Отрицательные и положительные значения ручек в Sytrus

[acc15]

Собственно сабж.. Чем отличаются? На слух есть разница, но поиск в хелпе и тут не помог..
PS: Ручки, те которые в матрице...

[=DRiNK=]

Modulation Setup
The knobs determine the amount of modulation - if the value is negative (turn the wheel at left) the modulation phase will be inverted. At the neutral level (Alt + left click a knob), there will be no modulation.

Filter Send Levels
This section adjusts the amount of signal sent from each operator to the filter modules. Negative values will send an inverted signal to the filter modules.

Pan, FX Send and Output
The first column sets the panning of its corresponding module (operator or filter). The default position is center.

The second column defines the amount of signal sent to the effects module. If you set this knob to a negative value, an inverted signal will be sent to the effects module. In the default neutral position (middle), no signal is sent to the effects module.

The third column defines the output amount for its corresponding module (operator or filter). A negative value will send an inverted signal to the output.

[dj_onick]

Инверсия? =DRiNK=, я правильно понял?